MPE/iX Commands Reference Manual (32650-90877)

250 Chapter7
Command List V
Commands HEADOFF thru LISTF
Use of the HIPRI option without SM or OP capability causes the following
warning to be displayed:
MUST HAVE 'SM' OR 'OP' CAP. TO SPECIFY HIPRI,
MAXIMUM INPRI OF 13 IS USED (CIWARN 1460)
RESTART Request to restart a spooled job that has been interrupted by the system
termination/restart. This parameter takes effect automatically when the
system is subsequently restarted with the START RECOVERY option. The
effect is to resubmit the job in its original form.
This parameter applies only to jobs initiated on spooled input devices. It is
ignored for other jobs. Default is that spooled jobs are not restarted after
system termination/restart.
device Class name or logical device number ( ldev ) of the device to receive listing
output. You cannot specify a magnetic tape unit. If the parameter is not a
valid LDEV or class name, an error is generated. Default is defined in the
system configuration.
NOTE Nonshareable device (ND) file access capability is required in order to use
this parameter.
outputpriority The output priority for job list file, if destined for spooled line printer.
This parameter is used to select the next spooled device file (on disk) for
output, from among all those contending for a specific printer. Must be a
value from 1 (lowest priority) to 13 (highest priority). When
outputpriority is 1, output is always deferred. To have output printed
from disk, use an
outputpriority of 2 or greater.
This parameter applies only to output destined for spooled output devices,
and is ignored for other output. Default is 8.
numcopies Number of copies of job listing to be produced. This parameter applies only
when listing is directed to a spooled device, and is ignored in other cases. If
the number of copies is less than 1, a warning is issued. The command still
executes with the default value of 1. If the number of copies is greater than
127, an error message is printed, and 127 copies are printed. Default is 1.
termtype The TERM= option is obsolete now that the JOB command cannot be used
interactively. In order to maintain backward compatability, the
termtype
parameter is still parsed, but it is not used. If the TERM= option is used, a
warning message will be displayed.
PRIVATE The PRIVATE option forces the job output $STDLIST to be a private
spoolfile. The spoolfile is only accessible to privileged users on the system.
Private spoolfiles may not be saved or copied. They may only be purged,
printed, or (within limits) altered.
SPSAVE If this option is used, the resulting job output $STDLIST spoolfile is created
with an SPSAVE disposition. This means that the spoolfile is not to be
purged after the last copy of it has been printed, but is instead retained in
the OUT.HPSPOOL group. SPSAVE may not be used if PRIVATE has been