MPE/iX Commands Reference Manual (32650-90864)

Chapter 6 427
Command Definitions P-R
PASXLLK
NOTE The formal file designators used in this command (PASTEXT, PASLIB, and
PASLIST) cannot be backreferenced as actual file designators in the
command parameter list. For further information, refer to the "Implicit FILE
Commands for Subsystems" discussion of the FILE command.
Operation Notes
The PASXLLK command compiles and links an HP Pascal/iX program into a file on disk. If
you do not specify textfile, the compiler expects input from the standard input device. If you
do not specify listfile, the compiler sends the program listing output to the formal file
designator PASLIST (default $STDLIST).
The object file created during compilation is a system-defined temporary file, $NEWPASS,
which is passed directly to the Link Editor as $OLDPASS. Link Editor overwrites progfile
and writes the linked program to $OLDPASS, if progfile is omitted, which can then be
executed.
NOTE This command is implemented as a command file. If you set the HPPATH
variable to null (SETVAR HPPATH ""), the command file is not executed, and
the command fails.
Use
This command may be issued from a session, job, or program. It may not be used in
BREAK. Pressing
Break suspends the execution of this command. Entering the RESUME
command continues the execution.
Examples
The following example compiles and links an HP Pascal/iX program entered through your
standard input device and stores the linked program in the file $OLDPASS. The listing will
be printed on your standard list device.
PASXLLK
To compile and link an HP Pascal/iX source program from the source file SOURCE, store it
in PROG, and send the listing to your standard list device, enter:
PASXLLK SOURCE,PROG
Related Information
Commands PASCAL, PASCALGO, PASCALPREP, PASXL, PASXLGO, PREP, RUN, LINK,
LINKEDIT
Manuals HP Pascal/iX Reference Manual
HP Pascal/iX Programmer's Guide
HP Link Editor/XL Reference Manual