MPE/iX Commands Reference Manual (32650-90864)

Chapter 3 225
Command Definitions C-E
ERRCLEAR
ERRCLEAR
Zeros out all HP predefined error-related variables. (Native Mode)
Syntax
ERRCLEAR
NOTE This command follows the optional MPE/iX command line syntax. Refer to
"Optional Format for MPE/iX Commands" at the beginning of this chapter.
Parameters
None
Operation Notes
This command is equivalent to the following:
• SETVAR CIERROR 0
• SETVAR HPCIERR 0
• SETVAR HPCIERRCOL 0
• SETVAR HPFSERR 0
Use
This command is available from a job or session. It is not available from a program or in
BREAK. Pressing
Break has no effect on this command.
Example
errclear
continue
run database
if hpcierr < 0 then
echo database warning ![abs(hpcierr)] detected, proceeding...
elseif hpcierr > 0 then
echo FATAL database error !hpcierr detected, halting...
escape
endif
Related Information
Commands ESCAPE, RETURN
Manuals None