Legato Networker ClientPak for MPE/iX Users Guide

61
Appendix A: Error Messages
NetWorker provides error messages to help you solve backup, recover, and
archive problems that you might encounter.
Error Messages
The error messages in Table 4 are listed in alphabetical order.
Table 4. NetWorker Error Messages
Message Cause Solution
Nothing marked for
backup
You started a backup
without marking files.
Start the backup or archive
again; mark at least one file.
‘09/30/12:00’ not valid,
time not changed
You asked NetWorker
to change the browse
time to a browse time
that was earlier than
the save time for the
file.
Re-enter the changetime
command and enter a time
that is later than the save time
for the file; for example, if the
save time for the file is
09/30/14:08:46, change the
browse time to 09/30/23:59:59.
NSRSAVE: invalid
time specification:
‘20d1978’
The time you entered
was an invalid time
format.
Enter the time using a valid
format. See “Valid Time
Formats” (on page 62).
‘12:20:14:00’ not valid,
time not changed”
The change time you
entered while trying to
recover was an invalid
time format.
Enter the change time using a
valid forma. See “Valid Time
Formats” (on page 62).