Legato Networker ClientPak for MPE/iX Users Guide

Recovering a Directory

Once you have started the NSRRECOV program, you can recover an entire

directory. This section assumes that you have started the NSRRECOV

program and have changed to the save set where the recovery directory

resides.

To recover an entire directory, follow these steps:

1. Mark the directory that you want to recover by entering the NetWorker

add command and the name of the directory:

recover> add

reports

The following message is displayed:

6 file(s) marked for recovery

2. (Optional) Verify the marked ﬁles in the recover list as follows:

recover> list

/projects/project1/reports/ @ Fri Nov 21 19:00:00 1997

/projects/project1/reports/rep1 @ Fri Nov 21 19:00:00 1997

/projects/project1/reports/rep2 @ Fri Nov 21 19:00:00 1997

/projects/project1/reports/rep3 @ Fri Nov 21 19:00:006 1997

/projects/project1/reports/rep4 @ Fri Nov 21 19:00:00 1997

/projects/project1/reports/rep5 @ Fri Nov 21 19:00:00 1997

6 file(s) marked for recovery

3. Start the recovery process by entering the recover command at the

NetWorker recover prompt:

recover> recover

NetWorker displays the following message:

Recovering 6 files into their original locations

FILES RESTORED : 5

Volumes needed (all on-line):

jupiter.012 at /source/rmt/data

Requesting 6 file(s), this may take a while...

Legato NetWorker for MPE/iX version 5.0

>> TURBO-STORE/RESTORE VERSION C.55.29 B5152AA