Legato NetWorker ClientPak for MPE/iX Installation Guide

• Turn the parallelism attribute on and off for server-initiated backups

• Turn the parallelism attribute on and off for client-initiated recovery

operations

For more information on setting variables, see “Conﬁguring the MPE Client on

the NetWorker Server” (on page 13).

Planning the Installation

The Legato NetWorker software is distributed on tape.

Important: If an earlier version of NetWorker is installed, follow the

instructions in “Removing NetWorker” (on page 19) before you install this

release of NetWorker.

To install NetWorker on an MPE client, you must meet each of the following

system requirements:

• HP 3000 MPE/iX release 5.5 operating system

• HP 3000 FOS STORE/iX or TurboSTORE/iX II (Prod no. B5151AA) or

TurboSTORE/iX 7x24 True-Online Backup (Prod no.B5152AA).

• MPE Patch MPEKX21 which includes the JXB1 patch. These patch

numbers are the correct patch numbers at the time of printing this guide.

• 30 MB of disk space

• NS 3000 Network Services must be up and running

• TCP/IP must be conﬁgured through the NS 3000 Network Services

• NetWorker Windows NT or UNIX server version 4.2 or above as the

server of the client

• Names of the servers of which the HP 3000 is a client

Please call the HP North American Response Center for the latest MPE Patch.