Legato NetWorker ClientPak for MPE/iX Installation Guide

Manually Creating the MPE Group

Installing the NSRHELP pages.

NetWorker installation was successful.

Once the installation is complete, if you created the MPE group

automatically, you must now create the MPE user (see “Creating the MPE

User” (on page 11)). If you did not create the MPE group automatically,

you must create the MPE group manually and you must create the user.

Manually Creating the MPE Group

If, while installing NetWorker, you responded no to creating the MPE group

automatically, the following message is displayed.

Exiting script so the installer can create a new group.

Important: You must create the MPE group manually. The installation script

will not be completed unless you create the new MPE group with the same

name NETWRKR.SYS. Changing the name of the group or altering its

capabilities is not supported and will cause NetWorker to fail.

1. When the NSRIZE script exits, create the MPE group as follows:

: NEWGROUP NETWRKR.SYS;CAP=BA,IA,PM,MR,DS,PH

2. After you create the group, you must run the NSRIZE script again:

./NSRIZE INSTALL

The following script is displayed:

NetWorker(TM) - Release 5 .0

rights reserved.

This product includes software developed by the

University of California, Berkeley and its

contributors.

NSRIZE is about to INSTALL NetWorker client software on

machine MARS.

Do you want to continue? [Yes] [Enter]

The group NETWRKR.SYS already exists. If there are any

NetWorker files in this group they will be overwritten.