Legato NetWorker ClientPak and Storage Node Installation Guide

34
Configuring the Storage Node on the NetWorker Server
3
d. Verify the binding for the tape drives (the differential tape dm):
io>
lpath 10/4/4.1.0
PATH: 10/4/4.1.0 LDEV: 31
ID: DLT7000 TYPE: TAPE
PMGR: SCSI_TAPE2_DM PMGRPRI: 10
LMGR: LOGICAL_DEVICE_MANAGER MAXIOS: 0
Repeat this verification step for lpath 10/4/4.2.0, 4.3.0, and 4.4.0
.
e. Verify the ldev specifications:
io>
ldev 30/34
LDEV: 30 DEVNAME: OUTDEV: 0 MODE:
ID: HPC1194F RSIZE: 128 DEVTYPE: MOSAR_AC
PATH: 10/4/4.0.0 MPETYPE: 24 MPESUBTYPE: 4
CLASS:
LDEV: 31 DEVNAME: OUTDEV: 0 MODE:
ID: DLT7000 RSIZE: 128 DEVTYPE: TAPE
PATH: 10/4/4.1.0 MPETYPE: 24 MPESUBTYPE: 8
CLASS: TAPE
...
LDEV: 34 DEVNAME: OUTDEV: 0 MODE:
ID: DLT7000 RSIZE: 128 DEVTYPE: TAPE
PATH: 10/4/4.4.0 MPETYPE: 24 MPESUBTYPE: 8
CLASS: TAPE
7. Save the configuration changes as follows:
a. Hold the configuration changes:
io>
hold
b. Exit the io section:
io>
exit
c. If you have followed the local convention for backing up the configuration
file, keep the changes:
sysgen>
keep
keeping to group CONFIG.SYS
Important: Check with system management to make sure you can keep the changes to
the configuration file.
Purge old configuration (yes/no)? y
d. Exit sysgen and reboot according to local convention:
sysgen> exit