Legato NetWorker ClientPak and Storage Node Installation Guide

33
Chapter 3: Configuration
3
5. Configure the robotic transport/"picker" and DLT tape drives. Use one of the
following IDs:
– HPC1194F (for robotics and DLT and STK libraries)
– DLT7000
– DLT4000
– COMP3840
For example:
io>
adev 30 id=HPC1194F path=10/4/4.0.0
io>
adev 31 id=DLT7000 path=10/4/4.1.0 mode=autoreply
io>
adev 32 id=DLT7000 path=10/4/4.2.0 mode=autoreply
io>
adev 33 id=DLT7000 path=10/4/4.3.0 mode=autoreply
io>
adev 34 id=DLT7000 path=10/4/4.4.0 mode=autoreply
6. Verify the bindings between the PATH, LDEV number, ID, PMGR (device drivers),
and LMGR attributes for each device configured.
a. Verify the binding for the device adapter (the fw/differential dam):
io>
lpath 10/4/4
PATH: 10/4/4 LDEV:
ID: HP28696A TYPE: DA
PMGR: FWSCSI_DAM PMGRPRI: 6
LMGR: MAXIOS: 0
Repeat this verification step for lpath 10/4/4.1, 4.2, 4.3, and 4.4.
b. Verify the binding for the targets (the transparent dm):
io>
lpath 10/4/4.0
PATH: 10/4/4.0 LDEV:
ID: PSEUDO TYPE: DA
PMGR: TRANSPARENT_MGR PMGRPRI: 6
LMGR: MAXIOS: 0
Repeat this verification step for lpath 10/4/4.1, 4.2, 4.3, and 4.4.
c. Verify the binding for the picker (the pass-through driver):
io>
lpath 10/4/4.0.0
PATH: 10/4/4.0.0 LDEV: 30
ID: HPC1194F TYPE: MOSAR_AC
PMGR: MO_SCSI_PTHRU_DM PMGRPRI: 10
LMGR: LOGICAL_DEVICE_MANAGER MAXIOS: 0
Repeat this verification step for lpath 10/4/4.1, 4.2, 4.3, and 4.4.