Legato NetWorker ClientPak and Storage Node Installation Guide

19
Chapter 2: Installation
2
Manually Creating the MPE Group
If you responded no to creating the MPE group while installing NetWorker, the
following message is displayed:
Exiting script so the installer can create a new group.
Important: If the MPE group was not was created automatically, the installation script
will not be completed unless you create the new MPE group with the same name,
NETWRKR.SYS. Changing the name of the group or altering its capabilities is not
supported and will cause NetWorker to fail.
To create the MPE group manually, follow these steps:
1. When the NSRIZE script exits, enter the following command:
: NEWGROUP NETWRKR.SYS;CAP=BA,IA,PM,MR,DS,PH
2. After you create the group, you must run the NSRIZE script again:
: ./NSRIZE INSTALL
The following script text is displayed:
This product includes software developed by the University of
California, Berkeley and its contributors.
NSRIZE is about to INSTALL NetWorker client software on
machine MARS.
Do you want to continue? [Yes]
[Enter]
The group NETWRKR.SYS already exists. If there are any
NetWorker files in this group they will be overwritten.
Do you wish to continue using the existing NETWRKR.SYS [yes]?
[Enter]
Installing the NetWorker executables.
Making the symbolic links.
Installing miscellaneous jukebox files.
Installing the NSRHELP pages.
NetWorker installation was successful.
Creating the MPE User
In order for automated NetWorker backups to run successfully, you must create the
MPE user. The MPE user has the following capabilities: SF, BA, IA, PH, SM, ND.
To create the MPE user, enter the following commands:
: NEWUSER NETWRKR.SYS;PASS=NEW_PASSWORD;
CAP=SF,BA,IA,PH,SM,ND;HOME=NETWRKR