Legato NetWorker ClientPak and Storage Node Installation Guide

18
Installing the NetWorker Software
2
The NETWRKR.SYS group is a special group that only exists for the NetWorker
daemons. This separate group allows you to identify the daemons in the SHOWJOB
listing. This group also allows you to stop the daemon jobs.
Important: You should not carry out any other work as NETWRKR.SYS.
To install the NetWorker software, follow these steps:
1. Change to the legato directory:
: CHDIR
/legato
2. Begin the installation with the following command:
:
./NSRIZE INSTALL
The following script text is displayed on the screen:
This product includes software developed by the University of
California, Berkeley and its contributors.
NSRIZE is about to INSTALL NetWorker client and storage node
software on machine MARS.
Do you want to continue? [Yes]
[Enter]
In order to install the NetWorker client and storage node
software a new MPE group must be added to your system. If you
wish NSRIZE to automatically create the MPE group, answer
’yes’ to the question below. If you wish to create the MPE
group manually respond ’no’. For further information please
read ’Installing the NetWorker Software’ and ’Manually
Creating the MPE Group’ sections in the Installation Guide.
Do you wish NSRIZE to create the group automatically [yes]?
[Enter]
If you responded no to creating the group automatically, see “Manually Creating the
MPE Group” on page 19.
If you responded yes to creating the group automatically, the installation continues
and the following message is displayed:
Installing the NetWorker executables.
Making the symbolic links.
Installing the NSRHELP pages.
Installing miscellaneous jukebox files.
NetWorker installation was successful.
Once the installation is complete, if you created the MPE group automatically, you
must now create the MPE user (see “Creating the MPE User” on page 19). If you did
not create the MPE group automatically, you must create the MPE group manually and
you must create the MPE user.