Legato NetWorker ClientPak and Storage Node Installation Guide

16
Removing an Earlier Release of NetWorker
2
9. Configure the system variables to customize the scheduled backups of the MPE
client from the NetWorker server. See “Setting System Variables for Server-
Initiated Backups” on page 26.
10. Affiliate the NetWorker MPE Client with the NetWorker MPE Storage Node. See
“Affiliating Clients to a Storage Node on the NetWorker Server” on page 29.
11. Configure the NetWorker storage node on the NetWorker server. See “Configuring
the Storage Node on the NetWorker Server” on page 30.
12. Install and configure the NetWorker Autochanger Support.
13. Enable and register the NetWorker software. See “How to Enable and Register
NetWorker” on page 53.
Removing an Earlier Release of NetWorker
If you have an earlier release of NetWorker ClientPak for MPE/iX installed on the
client, you need to remove it before you install release 5.5.
To remove the NetWorker software, follow these steps:
1. Copy NSRIZE from the /sys/netwrkr directory to another directory, for example:
: copy
/SYS/NETWRKR/NSRIZE , /tmp/NSRIZE
2. Change the group to PUB:
: CHGROUP PUB
3. Change to the /tmp directory:
: CHDIR
/tmp
4. Enter the following command to remove the NetWorker software:
: ./NSRIZE REMOVE
Installation System Requirements
The Legato NetWorker software is distributed on tape.
Important: If an earlier release of NetWorker is installed, follow the instructions in
“Removing an Earlier Release of NetWorker” on page 16 before you install this release
of NetWorker.
To install NetWorker on an MPE client, your system must meet each of the following
requirements:
• HP 3000 MPE/iX release 5.5 operating system or above.
• HP 3000 FOS STORE/iX or TurboSTORE/iX II (Prod no. B5151AA) or
TurboSTORE/iX 7x24 True-Online Backup (Prod no. B5152AA).
• MPE Patch MPEKXA7. The MPE patch numbers are the correct patch numbers at
the time of printing this guide.