Installing and Managing HP ARPA File Transfer Protocol Network Manager's Guide (36957-90157)

Appendix A 81
Error Messages
FTP Server Messages and Errors
MESSAGE: 200 Type set to !.
200 CAUSE: A TYPE command was received and accepted.
ACTION: None.
MESSAGE: 202 Command not implemented at this site.
202 CAUSE: The MPE/iX FTP server received a command that is not
implemented.
ACTION: This command cannot be used.
MESSAGE: “1”: !.
213 CAUSE: A file status (SIZE | MDTM) command was received and
accepted. This first parameter is the filename. The second contains
detailed information that differs depending on the command.
ACTION:
MESSAGE: MPE/iX system type.
215 CAUSE: The server received a SYST command.
ACTION: None.
MESSAGE: 220 HP ARPA File Transfer Protocol Server [!] (C)
Hewlett-Packard Co. 1990
220 CAUSE: The server has been started and is ready for user commands.
ACTION: Enter FTP commands.
MESSAGE: 221 Server is closing command connection
221 CAUSE: The server received a QUIT command and is shutting down.
ACTION: None.
MESSAGE: 226 Transfer complete.
226 CAUSE: A file transfer for a GET, PUT, LS or DIR has completed.
ACTION: None.
MESSAGE: 226 Transfer complete. Some records were truncated
during transfer.
226 CAUSE: A data transfer to MPE/iX resulted in some records being
truncated in the target file.
ACTION: It may be necessary to increase the maximum record size
using build parameters. Review the HP ARPA FTP User’s Guide for
more information on this subject.
MESSAGE: 230 User logged on
230 CAUSE: A USER command was received and accepted. The logon has
succeeded.