Installing and Managing HP ARPA File Transfer Protocol Network Manager's Guide (36957-90157)

76 Appendix A
Error Messages
FTP User Messages and Errors
MESSAGE: ExitOnError mode off. (FTPERR 34)
FTPERR 34 CAUSE: The EXITONERROR command was entered while the
exit-on-error feature was enabled.
ACTION: None.
MESSAGE: Invalid IP address. (FTPERR 35)
FTPERR 35 CAUSE: An invalid IP address was used while trying to open a
connection.
ACTION: Refer to the HP ARPA File Transfer Protocol User’s Guide for
assistance.
MESSAGE: Performing an ASCII transfer to a binary file.
(FTPWARN 36)
FTPWARN 36 CAUSE: An ASCII data transfer occurred to an MPE/iX binary file.
ACTION: If the intent was to transfer binary data, then use the BINARY
command to change transfer mode to binary. If the intent was to
transfer ASCII data, then specify an MPE/iX ASCII file using the
appropriate MPE/iX BUILD parameter. Refer to the HP ARPA File
Transfer Protocol User’s Guide for further assistance.
MESSAGE: Performing an binary transfer to a ASCII file.
(FTPWARN 37)
FTPWARN 37 CAUSE: An ASCII data transfer occurred to an MPE/iX binary file.
ACTION: If intent was to transfer ASCII data, then use the ASCII
command to change transfer mode to ASCII. If the intent was to
transfer binary data, then specify an MPE/iX binary file using the
appropriate MPE/iX BUILD parameter. Refer to the HP ARPA File
Transfer Protocol User’s Guide for further assistance.
MESSAGE: Error opening data connection. (FTPERR 38)
FTPERR 38 CAUSE: Internal Error. An I/O completion was received for an unknown
file number during the attempted establishment of a data connection.
ACTION: Note the circumstances and seek the assistance of your
Hewlett-Packard representative.
MESSAGE: ?Ambiguous command. (FTPERR 39)
FTPERR 39 CAUSE: A non-unique command string was entered at the ftp>
prompt.
ACTION: Check the command spelling and try again.
MESSAGE: Connected to !. (FTPINFO 40)
FTPINFO 40 CAUSE: A connection request to a remote FTP server was accepted.
ACTION: None.