Installing and Managing HP ARPA File Transfer Protocol Network Manager's Guide (36957-90157)

72 Appendix A

Error Messages

FTP User Messages and Errors

These error and warning messages may be returned to FTP users on

MPE/iX while using the FTP user program.

In the following list of messages and errors, the exclamation point (!)

represents a variable value.

MESSAGE: Error in loading keywords from FTP catalog. (FTPERR 3)

FTPERR 3 CAUSE: The User-FTP program encountered an error while trying to

load the FTP command keywords onto its program stack from the FTP

catalog. This probably indicates an internal FTP error.

ACTION: Check the permissions on the ﬁle FTPC000.ARPA.SYS. The

security for READ must be set to ANY. If the permissions are correct,

note the circumstances and contact your Hewlett-Packard

representative for assistance.

MESSAGE: Command must be less than or equal to 255 characters.

(FTPERR 5)

FTPERR 5 CAUSE: The user entered an FTP command which exceeded 255

characters.

ACTION: Try entering the command using fewer characters.

MESSAGE: ?Invalid command. (FTPERR 6)

FTPERR 6 CAUSE: An invalid or unknown command was issued to the User-FTP

program.

ACTION: Check the command for spelling. Use the help command for a

list of supported HP ARPA FTP commands.

MESSAGE: Not connected. (FTPERR 8)

FTPERR 8 CAUSE: An FTP command was entered which requires a host

connection and no connection was established.

ACTION: Open a host connection using the OPEN command and try the

command again.

MESSAGE: Cannot connect to host: ! (FTPERR 9)

FTPERR 9 CAUSE: FTP was unable to open a host connection. Typically this FTP

error is accompanied by a socket error which provides more

information.

ACTION: Check the spelling of the host name or IP address. Otherwise,

seek the assistance of your Node Manager.

MESSAGE: Invalid Command Syntax. (FTPERR 10)

FTPERR 10 CAUSE: An FTP command was entered with invalid parameter syntax.