Installing and Managing HP ARPA File Transfer Protocol Network Manager's Guide (36957-90157)

40 Chapter 2
Verify Installation and Update LAN Configuration
Restarting the Network
Restarting the Network
In order to activate the changed configuration file, you need to restart
the network.
1. If you have the Network Services (NS 3000/iX) installed, stop them
by first issuing NSCONTROL STOP followed by NSCONTROL ABORT.
2. Next, to stop the transport, issue a NETCONTROL STOP.
3. Once the network has been stopped, issue the following NETCONTROL
commands:
• NETCONTROL NI=Loop_niname;START to restart the loopback NI
(where Loop_niname is the name of the configured NI of type
LOOP) and,
• NETCONTROL NI=niname;START for each configured NI to restart
the links.
4. If you have the Network Services installed, restart them with
NSCONTROL START.