Installation/Upgrade Procedures for SHAREPLEX

SHAREPLEX
1-16
Installation Appendix
This Appendix covers the following subjects:
• Converting from an account installation to global installation. With the 9.7 release of NetBase,
account installations are no longer supported. Before updating to 9.7 NetBase, the account
installation must be removed.
• Updating from a global installation of NetBase that is previous to the 9.6 Release.
If you have any questions, or if you are unsure about any of the steps, please contact Technical
Support at (714)-720-1434.
Converting From an Account Installation to a Global Installation
The Account installation must be removed prior to installing the 9.7 Release. Perform the steps
below for removing the Account installation prior to updating.
_____
1. Logon as MGR.NETBASE.
_____
2. Use NBCTRL to remove the NetBase segments from account libraries:
:RUN NBCTRL.PUB.NETBASE
*> CONFIG
C> REMOVE @
Verify that the NetBase segments have been removed from all account libraries:
C> SHOW
_____ 3. Proceed to Step 1 in the “Installation Steps” section.