HP RPG/iX Utilities Reference Manual (30318-90006)

2- 202
NOTE If the terminal is unexpectedly locked out at this point, see the section on Recovery
Procedures.
Scroll Set
While in SHOW mode, you can increase your scrolling capabilities by switching to Scroll set. Again, this is
accomplished by pressing F1.
The softkeys have the following functions when Scroll set is activated:
F1 Switch to Master set.
F2 Display first page.
F3 Display last page.
F4 Move cursor to Command Window.
F5 Scroll forwards a page.
F6 Scroll backwards a page.
F7 Scroll forwards 1/2 page.
F8 Scroll backwards 1/2 page.
Execution mode: Block.
Examples
The following are legal abbreviations which may be used with the SHOW command and its pa-
rameters:
S F C Enter Show mode displaying the first line of the source file with the column indicator.
S 10 Enter Show mode and display line 10 with the appropriate Record Specification form.
SHO Enter Show mode.
In the first example, the SHOW FIRST command brings the Header Specification form to the screen along
with the first line of the source file (1). In the second display, the cursor has been moved into position, and
new data is added to the first line. Note that RISE is now in Block mode, and the ENTER key must be
pressed to make changes to the first line permanent (2).
> SHOW FIRST
Bad graphic