HP e3000/iX Network Planning and Configuration Guide (36922-90037)

Chapter 5 87
Introductory Screens
To Begin the Configuration Process
To Select Guided Configuration
The NS Configuration screen (#166) in Figure 5-4 is displayed if you
press the
[NS] key at the Main screen (#2) in Figure 5-3.
Figure 5-4 NS Configuration Screen
Step 1. If you are using domain names for network access, replace the node
name in the field at the bottom of the screen with this system’s domain
name and press the
[Save Data] key. If not using domain names, leave
the node name as is.
Step 2. Press the
[Guided Config] key to proceed with guided configuration of
LAN.
Guided/Unguided Configuration
Hewlett-Packard recommends that you press the [Guided Config] key to
select the guided configuration branch whenever you need to initially
configure a network interface. Guided configuration supplies many
default values for your configuration and requires that you visit a
minimal number of screens. This manual provides information on every
screen available to you through unguided NS configuration.
The
[Unguided Config] key is used to modify configuration values that
are not available in the guided screens. To use the unguided
configuration screens, refer to the NS 3000/iX NMMGR Screens
Reference Manual.