HP e3000/iX Network Planning and Configuration Guide (36922-90037)

82 Chapter5
Introductory Screens
To Begin the Configuration Process
To Begin the Configuration Process
The procedures that follow describe how to modify the NMMGR
configuration file for the introductory screens.
To Start NMMGR
Node manager (NM) or network administrator (NA) capabilities are
required to run this program.
To run NMMGR:
1. Type NMMGR.PUB.SYS at the system prompt (:).
2. Press
[RETURN].
NOTE As of version 4.0 of the operating system, you can modify the link
configurations in NMCONFIG.PUB.SYS when the Network Services
are active. However, the network must be stopped and restarted for the
changes made in NMMGR to be implemented.
If NS is down, you will see the following two messages in response to
the NETCONTROL STATUS command:
TRANSPORT NOT ACTIVE. (NETEXPORTWARN 0001) ENCOUNTERED
ONE OR MORE WARNINGS WHILE PROCESSING COMMAND.
(CIWARN 4437)
To Open the Configuration File
The Open Configuration/Directory File screen (#1) in Figure 5-2 is the
first screen displayed when you run NMMGR.