HP e3000/iX Network Planning and Configuration Guide (36922-90037)

66 Chapter4
Planning for Node Configuration
Node Worksheet Information
Physical path of
LANIC
LAN Configuration This is the location of the LANIC
device adapter card. Run IOMAP
utility to determine the physical path
for the LAN adapter. Refer to the
system documentation for your HP
3000 model for further details
regarding physical path.
Physical path of
device adapter
FDDI Configuration This is the location of the FDDI device
adapter card. Run IOMAP utility to
determine the physical path for the
FDDI adapter. Refer to the system
documentation for your HP 3000
model for further details regarding
the physical path.
Physical path of
Token Ring device
adapter
Token Ring Configuration This is the location of the Token Ring
device adapter card. Run IOMAP
utility to determine the physical path
for the Token Ring adapter. Refer to
the system documentation for your
HP 3000 model for further details
regarding physical path.
Physical path of
device adapter
100VG-AnyLAN Configuration This is the location of the
100VG-AnyLAN device adapter card.
Run IOMAP utility to determine the
physical path for the 100VG-AnyLAN
adapter. Refer to the system
documentation for your HP 3000
model for further details regarding
the physical path.
Link Speed 100VG-AnyLAN Configuration This is the desired speed at which link
should operate. Valid values are 10 or
100 MBit/sec.
Full Duplex Mode 100VG-AnyLAN Configuration If the link is operating in 10 MBit/sec,
should full duplex mode be used. This
is based on the capability of the
hub/switch to which the adapter is
connected.
Physical path of
device adapter
100Base-T Configuration This is the location of the 100Base-T
device adapter card. Run IOMAP
utility to determine the physical path
for the 100Base-T adapter. Refer to
the system documentation for your
HP 3000 model for further details
regarding the physical path.
Field Screen Description