HP e3000/iX Network Planning and Configuration Guide (36922-90037)

Chapter 6 105

Conﬁguring a LAN, Token Ring, FDDI, 100VG-AnyLAN, 100Base-T Node

To Conﬁgure a 100VG-AnyLAN Network Interface

To Conﬁgure a 100VG-AnyLAN Network

Interface

The 100VG-AnyLAN Conﬁguration screen (#287) in Figure 6-5 is

displayed when you press the

[Conﬁg Network] key at the Network

Transport Conﬁguration screen (#42) with an NI type of 8

(100VG-AnyLAN). Refer to Chapter 5, “Introductory Screens,” for

information on the Network Transport Conﬁguration screen.

Figure 6-5 100VG-AnyLAN Conﬁguration Screen

Step 1. In the IP address ﬁeld, enter the internet protocol (IP) address for the

node being conﬁgured. An example of an address is:

C 192.191.191 009.

Step 2. The IP subnet mask is optional. If entering one, tab to the IP subnet

mask ﬁeld and enter the number in the same format as an IP address.

Step 3. Move to the Link name ﬁeld. Enter a link name to represent the

100VG-AnyLAN card for which you are conﬁguring a link. This name

must be unique to the node.

Step 4. Tab down to the ﬁeld called Physical path of device adapter.

Step 5. Press the

[Save Data] key to save the 100VG-AnyLAN link

conﬁguration. If you need to identify neighbor gateways, press the

[Neighbor Gateways] key and proceed to the section in this chapter called