HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

88 Chapter4
Preparing Your System
4.6 Creating the CSLT using HPINSTAL
Verifying the second CD-ROM . . . Done.
The second CD-ROM volume has been mounted.
Continuing with installing from the CD-ROM volume MPE_ v.uu.ff _2.
14.After the CSLT is created, dismount the tape, label it CSLT v.uu.ff , and set it to read
only.
The final response messages vary depending upon the CSLT option you selected.
Basically, the response is:
Phase I of HPINSTAL is now complete:
15.A warning message displays, if applicable.
WARNING -- This program cannot install the products listed below.
(INSTWARN #1)
Record on your checklist any products HPINSTAL cannot completely install.
HPINSTAL will automatically cleanup files, exit, and return you to the MPE/iX prompt.
Purging temporary files and cleaning up...
16.If you are creating a CSLT on a local system to apply to a Remote system, proceed to
Step 17.
If you are performing an Add-on or Update task for a local system only, omit Step 17,
and go to the next section on your checklist.
Remote Tasks
17.Refer to Appendix E , “CD-ROM Resources,” for directions on creating multiple copies of
the CSLT with the SLTCOPY command for use at remote systems.
If you are creating additional modified CSLTs for use on remote systems, reinvoke
HPINSTAL and select option 3, “Create a CSLT for another system,” for each CSLT you
need. If each remote system is unique, you will need to modify the PRODLIST file for
each system. Refer to Appendix E , “CD-ROM Resources,” for directions on creating
additional PRODLIST files.
• Creating the CSLT using HPINSTAL completed. Go to the next section on
your checklist.