HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

444 AppendixH
Error Messages and Warnings
Stage/iX Messages (STAGEMAN)
Action. Determine why the open of the contents file failed. Contact
your Hewlett-Packard Response Center for assistance.
1020 Message “/” not allowed in staging area names. (STAGEMAN
1020)
Cause A slash (“/”) was found in the staging area parameter.
STAGEMAN uses the staging area name for building a
directoryunder/SYS/hpstage/ (/SYS/hpstage/stage_name).
Since the staging area must be confined to a single
directory, slashes are not allowed.
Action Re-enter the command with a legal staging area name.
1021 Message Invalid staging area name “ name ”. (STAGEMAN 1021)
Cause An illegal staging area name was provided as a parameter.
STAGEMAN uses the staging area name for building a
directoryunder/SYS/hpstage/ (/SYS/hpstage/stage_name).
Since the staging area name must be valid as a directory
name, the restrictions for HFS directory names apply.
Action Re-enter the command using a valid staging area name.
Do a HELP on the CREATE command for information on
how to name the staging area.
1022 Message Can't use reserved word “BASE” for a staging area
name. (STAGEMAN 1022)
Cause The user attempted to use “BASE” as a staging area
parameter. Since users must be able to do a SET BASE to
move back to the Base, STAGEMAN does not allow this
reserved word as a staging area parameter to any other
command. To avoid confusion, the check for “BASE” is not
case- sensitive (“Base”=“BASE”).
Action Chooseanother staging area name. You may use the string
“BASE” within a staging area name (e.g., “Base_OS”).
1023 Message Staging area “
name ” is active. Can’t
command . (STAGEMAN 1023)
Cause The user attempted a change operation on the active
staging area. Since the files belonging to the active staging
area are in use, STAGEMAN does not allow any changes
to that staging area to avoid the possibility of corrupting
the environment and/or the system.
Action To make changes to an active staging area you must boot
from the Base so that the staging area is no longer active.
1024 Message Staging area “
name ” is set for
next boot. Can't command. (STAGEMAN 1024)
Cause The user attempted a change operation on a staging area
that is set to be used on the next system boot (i.e., a SET