HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

438 AppendixH
Error Messages and Warnings
SLTCOPY Messages
SLTCOPY Messages
Message Invalid file name.
Cause The file name that you entered does not meet the MPE
syntax requirements for file names. Note that you cannot
use HFS syntax (such as /SYS/PUB/tapefile) for file names
supplied to SLTCOPY.
Action Enter a different file name that meets MPE syntax
requirements.
Message Undefined system file.
Cause File name entered is undefined to the system. Note that
you cannot use HFS syntax (such as /SYS/PUB/tapefile)
for file names supplied to SLTCOPY.
Action Enter a different file name that meets MPE syntax
requirements.
Message Copy# on LDEV # is bad. The tape may be too short or an
I/O error occurred.
Cause Most often, this means that the tape onto you tried to
make the copy was shorter than the master tape.
Action Rerun SLTCOPY using a longer tape onto which to make
the copy, or recreate the master on a shorter tape.
Message Purge failed on old file
Cause Unable to purge the disk file with the same name as the
file name you entered. Occurs only with Option 1 (Copy
tape to disk).
Action Purge the disk file and restart SLTCOPY.
Message Open failed for LDEV #
Cause SLTCOPY couldn't access the tape drive.
Action Check the tape drive cable connections, its configuration,
and whether or not it's available to this process.
Message Open failed for COPY1 Operation inconsistent with access
type (FSERR40)
Cause You attempted to copy to more than one remote tape, when
NOWAITIO was in effect.
Action If you need to copy to multiple remote tapes, make sure
the appropriate file equations are set (see Chapter 5 ,
“Modifying Your System,”), and reinvoke SLTCOPY using
the WAITIO option:
:SLTCOPY; INFO="WAITIO"