HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

Appendix H 431
Error Messages and Warnings
Installer Error Messages (INSTERR)
• Contact your Response Center if further assistance is
required.
239 Message Invalid Catalog AICAT000 in the INSTALL.SYS
group.
The Catalog VUF could not be recovered (INSTERR
#239)
Cause The catalog, AICAT000, is missing its VUF.
Action • If you are installing a PowerPatch tape, RESTORE
AUTOINST and AICAT000 from the PowerPatch tape.
If you are not installing PowerPatch, UPDATE with the
SLT provided by HP, and ensure that the file exists
after the UPDATE.
• Do a LISTF,2 of the file and ensure the CODE is
MGCAT.
• Run AUTOINST again.
• Contact your Response Center if further assistance is
required.
240 Message AUTOINST CATALOG VUF = v.uu.ff. Invalid Catalog
AICAT000
in INSTALL.SYS group The Catalog does not match
version expected
by AUTOINST. (INSTERR #240)
Cause The AUTOINST V.U.F. does not match the V.U.F. found in
its catalog, AICAT000.INSTALL.SYS.
Action • If you are installing a PowerPatch tape, RESTORE
AUTOINST and AICAT000 from the PowerPatch tape.
If you are not installing PowerPatch, UPDATE with the
SLT provided by HP, and ensure that the file exists
after the UPDATE.
• Do a LISTF,2 of the file and ensure the CODE is
MGCAT.
• Run AUTOINST again.
• Contact your Response Center if further assistance is
required.
241 Message Not used
242 Message The installer failed to modify the job and
session
limits. (INSTERR #242)
Cause The COMMAND intrinsic returned a nonzero command
error when AUTOINST programmatically attempted to
set the job and session limits to 1,1.
Action • Manually execute the LIMIT command to ascertain why