HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

430 AppendixH
Error Messages and Warnings
Installer Error Messages (INSTERR)
except LDEV 1.
• Store user files to tape and then purge them.
Restore the files from tape at the end of the
installation.
— Transmission errors - Clean tape heads and check
for hardware errors.
— Corrupt files - Manually RESTORE the corrupt files
from the CSLT/STORE tape. If successful, this
indicates there were transmission errors.
• Take appropriate corrective measures, and run
AUTOINST again.
• Contact your Response Center if further assistance is
required.
237 Message PowerPatch Release VUF is older than Subsys
Release
VUF (INSTERR #237)
Cause The PowerPatch tape being installed is older than the last
Powerpatch tape installed on the system.
Action • Print the file HPSWINFO.PUB.SYS and refer to line 4
of the file to determine the V.U.F. of the SUBSYS
currently installed on the system.
• Refer to the accompanying READ BEFORE
INSTALLING to determine the SUBSYS releases
supported by this PowerPatch tape.
• Get a newer PowerPatch tape.
• Contact your Response Center if further assistance is
required.
238 Message Unable to open the AUTOINST message catalog
(INSTERR #238)
Cause Either the AUTOINST catalog, AICAT000.INSTALL.SYS
is missing or it is not a valid catalog.
Action • Ensure that the file AICAT000.INSTALL.SYS exists on
the system.
— If it does not and you are installing a PowerPatch
tape, RESTORE AUTOINST and AICAT000 from
the PowerPatch tape. If you are not installing
PowerPatch, UPDATE with the SLT provided by HP,
and ensure that the file exists after the UPDATE.
— If the file does exist, do a LISTF,2 of the file and
ensure the CODE is MGCAT.
— Run AUTOINST again.