HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

Appendix H 427
Error Messages and Warnings
Installer Error Messages (INSTERR)
required.
221 Message Encountered an error while retrieving the CI
variable,
variable name. (INSTERR #221)
Cause Could not retrieve the value of the indicated CI variable.
Action • Use SHOWVAR variable name to check the status of
the variable.
• Print the INITCIVR.INSTALL. There should be a line
with a SETVAR command for the indicated variable. If
the line does exist, execute INITCIVR and run
HPINSTAL again.
• If INITCIVR.INSTALL.SYS does not exist or does not
contain the SETVAR command for the listed CI variable,
VSCLOSE both CD-ROM volumes and follow the setup
procedures in the HPINSTAL manual. Run HPINSTAL
from the start.
222 Message Invalid CI variable type, should be string type
(INSTERR #222)
Cause The retrieved CI variable was not a string type as
expected. This error is usually issued in conjunction with
INSTERR #221.
Action • Use SHOWVAR variable name to check the status of
the variable.
• Print the INITCIVR.INSTALL. There should be a line
with a SETVAR command for the indicated variable. If
the line does exist, execute INITCIVR and run
HPINSTAL again.
• If INITCIVR.INSTALL.SYS does not exist or does not
contain the SETVAR command for the listed CI variable,
VSCLOSE both CD-ROM volumes and follow the setup
procedures in the HPINSTAL manual. Run HPINSTAL
again from the start.
223 Message Could not get volume information on first CD-ROM
volume name
(INSTERR #223)
Cause HPVOLINFO failed while attempting to get information
on the first CD-ROM volume.
Action • Ensure the CI variable MPE_VOL_1 contains the name
of the first CD-ROM volume (in the form of MPE_
v.uu.ff _1 where v.uu.ff is the system VUF of the release
contained on the CD-ROMs) that is mounted on the
system.