HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

426 AppendixH
Error Messages and Warnings
Installer Error Messages (INSTERR)
Cause An attempt to set a file equation for the link editor help
and catalog files through the HPICICOMMAND intrinsic
failed. The FILE Command Table is possibly full.
Action • Check if any further FILE commands can be entered
with the FILE command.
• RESET any user file equations.
• Take appropriate corrective measures and run
HPINSTAL again. HPINSTAL will reissue any
required file equations.
• Contact the Response Center if further assistance is
required.
218 Message MESSAGE patchid Too many dependent patches
(INSTERR #218)
Cause Invalid data in AUTODEP file.
Action Note the displayed patchid, save the PATCHAUD and
INSTERRS files, and call the Response Center for
assistance.
219 Message FREADLABEL failed on filename. (INSTERR #219)
Cause A call to the intrinsic FREADLABEL failed when
CUSTOM attempted to read a file label of either
FILEINFO.INSTALL.SYS or DEPINFO.INSTALL.SYS.
Action • Document any error message text that occurred prior to
the error.
• Ensure that the specified file exists in the
INSTALL.SYS group.
• If necessary, follow the instructions in your installation
manual to initialize your system by using the SETUP
process.
• Run HPINSTAL again.
• Contact the Response Center if further assistance is
required.
220 Message Verification of VUF failed on filename file.
(INSTERR #220)
Cause The VUF in the file label of the specified file does not
match the VUF of the compact disk as specified in the CI
variable mpe_targ_vuf.
Action • Follow the instructions in your installation manual to
initialize your system by using the SETUP process.
• Run HPINSTAL.
• Contact the Response Center if further assistance is