HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

424 AppendixH
Error Messages and Warnings
Installer Error Messages (INSTERR)
Cause An attempt to set the HPINSTAL environment variables
though the command script, INITCIVR.INSTALL.SYS,
failed.
Action • Check the CI error message preceding the INSTERR
#209 message and take appropriate corrective action.
• If INITCIVR.INSTALL.SYS does not exist, VSCLOSE
both CD-ROM volumes and follow the setup procedures
in the HPINSTAL manual.
210 Message HPVOLINFO error while attempting to access
volume name
. (INSTERR #210)
Cause A call to HPVOLINFO to determine whether the second
CD-ROM volume is mounted has failed with an
unexpected error status.
Action • Check the state of the CD-ROM volumes with the
DSTAT command.
• Ensure that all mounted CD-ROMs are listed as
ONLINE and MASTER state.
• Ensure that the listed CD-ROM volumes are physically
mounted on the system.
• If there is only one CD-ROM drive, ensure that the
original CD-ROM volume has been VSCLOSED and is
offline before inserting another volume.
• HPINSTAL can be run again after the first CD-ROM
volume has been mounted (ONLINE/MASTER). If
there are two CD-ROM drives, both CD-ROM volumes
should be mounted before running HPINSTAL.
211 Message Could not RESET file equation for NL.PUB.SYS
(INSTERR #211)
Cause An attempt to reset the file equation for NL.PUB.SYS
through the hpcicommand intrinsic failed.
Action Document all the messages prior to the error. Save the file
AUTOLOG and then report the problem to the Response
Center for assistance.
212 Message Could not set FILE equation for NL.PUB.SYS=NL
(INSTERR #212)
Cause An attempt to set a file equation for NL.PUB.SYS through
the hpcicommand intrinsic failed. FILE Command Table is
possibly full.
Action • Check if any further FILE commands can be entered
with the FILE command.
• RESET any user file equations.