HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

Appendix H 417
Error Messages and Warnings
Installer Error Messages (INSTERR)
(INSTERR #184)
Cause The installer invoked SYSGENto make a modification to a
SYSGEN internal file.
Action • Print file AUTOLOG.INSTALL.SYS to view detailed
error from SYSGEN.
• Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
185 Message The installer encountered an error purging
TARGVUF.
(INSTERR #185)
Cause The installer failed to purge the file TARGVUF.
Action • Document any error message text prior to the error.
• Examine file for accessors other than the installer.
• If file is being accessed, free up file.
• Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
186 Message Error accessing installer variable:
MPE_TARG_VUF. (INSTERR #186)
Cause Could not retrieve the value of the indicated CI variable
MPE_TARG_VUF.
Action • Document any error message text prior to the error.
• Use SHOWVAR MPE_TARG_VUF to check the status
of the variable.
• Print the INITCIVR.INSTALL. There should be a line
with a SETVAR command for the indicated variable. If
the line does exist, execute INITCIVR and run
HPINSTAL again.
• If INITCIVR.INSTALL.SYS does not exist or does not
contain the SETVAR command for the listed CI variable,
VSCLOSE both CD-ROM volumes and follow the setup
procedures in the HPINSTAL manual. Run HPINSTAL
from the start.
187 Message The installer encountered a corrupt variable:
MPE_TARG_VUF.
(INSTERR #187)
Cause The data retrieved from the variable MPE_TARG_VUF is