HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

Appendix H 409
Error Messages and Warnings
Installer Error Messages (INSTERR)
Cause AUTOGEN and AUTORLNK from the PowerPatch tape
should have the same file vuuff. This error can only be
caused if two different PowerPatch tapes are in use.
Action For AUTOINST:
• Restore A@,F@ from the correct PowerPatch.
• Take appropriate corrective measures and run
AUTOINST to start installation again.
• Contact the Response Center if further assistance is
required.
For HPINSTAL:
• Restart HPINSTAL; it will restore the files from the
PowerPatch tape again. If the error occurs again,
contact the Response Center for assistance.
155 Message Error while getting information from filename
(INSTERR #155)
Cause A file system intrinsic failed on the named file.
Action If the file is an AUTOGEN, AUTODEP, or AUTORLNK
file, restore the file from the PowerPatch tape and restart.
If it fails again, save the displayed information files, patch
and installation errors, and call the Response Center.
156 Message Relinker patch patch-id not found in AUTORLNK
(INSTERR #156)
Cause A relinker patch found in the AUTOGEN file is not found
in the AUTORLNK file.
Action Save the PATCHAUD file, the INSTERRS file, and call the
Response Center.
157 Message Error while creating AUXHDR. (INSTERR #157)
Cause The installer is trying to get information from the
auxiliary header in the OSSOM and failed while doing so.
Action Note the error messages, escape codes displayed, and
contact the Response Center.
158 Message Failed to Createprocess on AUTOSPTH. (INSTERR
#158)
Cause Patch selector is trying to createprocess on AUTOSPTH to
get relinker information and the CREATEPROCESS
intrinsic has failed.
Action • Check the accompanying error message and the escape
code displayed for CREATEPROCESS.
• Take corrective action and run the installer again.