HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

Appendix H 401
Error Messages and Warnings
Installer Error Messages (INSTERR)
• Contact the Response Center for further assistance if
required.
116 Message Error occurred while reading the PRODINFO file.
(INSTERR #116)
Cause CUSTOM failed while trying to access the appropriate
PRODINFO.
Action • Initialize the system by using the SETUP initialization
process.
• Run HPINSTAL.
• Contact the Response Center if further assistance is
required.
Message 117-118 Not used
119 Message Unable to open file filename. (INSTERR #119)
Cause CUSTOM failed while trying to open the specified file.
Action • Check to see if the file exists. If it does not, initialize the
system by using the SETUP initialization process.
• Run HPINSTAL.
• Contact the Response Center if further assistance is
required.
120 Message 120 Not used
121 Message Unable to locate FOS STORE files. (INSTERR #121)
Cause No files with the filetype of FOS STORE were located in
the FILEINFO.INSTALL.SYS file.
Action • Check for the existence of FILEINFO.INSTALL.SYS.
The file should be a KSAMXL file.
• If the file does not exist, follow the instructions in the
installation guide to perform initialization by using the
SETUP process.
• Run HPINSTAL.
• Contact the Response Center if further assistance is
required.
122 Message HPINSTAL_CUSTOM FATAL ERROR errorno. (INSTERR
#122)
Cause Fatal error encountered in CUSTOM.
Action Contact the Response Center for assistance.
Message 123-124 Not used
125 Message Unable to obtain file information for filename.
(INSTERR #125)