HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

Appendix H 397
Error Messages and Warnings
Installer Error Messages (INSTERR)
required.
103 Message The installer failed to build AUTOLOG.INSTALL.
(INSTERR #103)
Cause The installer failed to build the file AUTOLOG.INSTALL.
Action • Check for free disk space to build file. There are two
methods for obtaining additional disk space:
— Use the ALTERVOL command in VOLUTIL to set the
permanent and transient space allocation
assignments to 100% on all system volumes except
LDEV 1.
— Store user files to tape and them purge them.
Restore the files from tape at the end of the
installation.
• Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
104 Message The installer failed to open AUTOLOG.INSTALL
with append
access. (INSTERR #104)
Cause The installer issued a file equation so that the file
AUTOLOG can be used as $STDOUT for the subsystems
called by the installer.
Action • FILE Command Table is possibly full. Do a LISTEQ
command to determine which USER file equations can
be RESET. RESET any USER file equations.
• Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
105 Message A CLEANXL failed on an NM Library. The installer
cannot continue.
(INSTERR #105)
Cause The installer called the link editor to perform a CLEANXL
on either the stated XL or the staged NL after purging
SOMs and in preparation for adding subsys or patched
SOMs. The installer could have also called the link editor
to perform a CLEANXL on either the stated XL or the
staged NL prior to building the START IMAGE and then
producing the CSLT.
Action • Print file AUTOLOG.INSTALL.SYS to view detailed
error from link editor, and to determine where in the