HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

Appendix H 385
Error Messages and Warnings
Installer Error Messages (INSTERR)
• Contact the Response Center if further assistance is
required.
69 Message Copy of SPLINTR.PUB.SYS to SPLINTR.INSTALL.SYS
failed.
(INSTERR #69)
Cause The installer was attempting to copy SPLINTR.PUB.SYS
to SPLINTR.INSTALL.SYS.
Action • Examine file SPLINTR.INSTALL.SYS for accessors
other than the installer.
• If file is being accessed, free up file.
• Check for free disk space to copy file, and if needed free
up disk space. There are two methods for obtaining
additional disk space:
— Use the ALTERVOL command in VOLUTIL to set the
permanent and transient space allocation
assignments to 100% on all system volumes except
LDEV 1.
— Store user files to tape and them purge them.
Restore the files from tape at the end of the
installation.
• Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
70 Message A call to the LINKEDITOR by the installer failed.
(INSTERR #70)
Cause The link editor variables LKEDSTAT and/or LKEDCMD
were checked after a call to the link editor by the installer.
The variables were found to contain error values.
Action • Record the error messages preceding this message.
• Print file AUTOLOG.INSTALL.SYS to view detailed
error from link editor.
• Check error message cause and action in the HP Link
Editor/iX Reference Manual.
• Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
71 Message The installer failed to purge TEMPNL when
patching
the OS SOM. (INSTERR #71)