HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)
382 AppendixH
Error Messages and Warnings
Installer Error Messages (INSTERR)
• Ensure group for BUILDINT has sufficient capabilities.
(need CAP=PH).
• Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
59 Message Setting file equation SPLINTR failed. (INSTERR
#59)
Cause Setting the SPLINTR file equation required by the CM
intrinsic builder/patcher BUILDINT failed.
Action • FILE Command Table is possibly full.
• Check if any further file commands can be entered with
the FILE command.
• RESET any USER file equations.
• Take appropriate corrective measures and run the
installer again. The installer will reissue any needed
file equations.
• Contact the Response Center if further assistance is
required.
60 Message Setting file equation INTDECL failed. (INSTERR
#60)
Cause Setting the INTDECL file equation required by the CM
intrinsic builder/patcher BUILDINT failed.
Action • FILE Command Table is possibly full.
• Check if any further file commands can be entered with
the FILE command.
• RESET any USER file equations.
• Take appropriate corrective measures and run the
installer again. The installer will reissue any needed
file equations.
• Contact the Response Center if further assistance is
required.
61 Message Error occurred while patching System INTRINSICS
file. (INSTERR #61)
Cause The installer checks the results of the calls to the CM
intrinsic builder/patcher BUILDINT.PUB.SYS and the
NM intrinsic patcher ABLDINTX.INSTALL.SYS by
checking the status of the system JCW. A nonzero value
(error) value was returned.
Action • Print the file AUTOLOG.INSTALL.SYS to check for