HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

378 AppendixH
Error Messages and Warnings
Installer Error Messages (INSTERR)
The installer invoked SYSGEN to build the CSLT.
SYSGEN encountered an error and the installer trapped
on the error condition.
Action • Print file AUTOLOG.INSTALL.SYS to view detailed
error from SYSGEN.
• Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
47 Message Error executing SAINT commands while building
START IMAGE.
(INSTERR #47)
Cause SAINT encountered an error in building new START
image. The installer invoked SAINT to build the new
START image. SAINT encountered an error and the
installer trapped on the error condition.
Action • Print file AUTOLOG.INSTALL.SYS to view detailed
error from SAINT.
• Take appropriate corrective measures and run the
installer again.
• Contact the Response Center if further assistance is
required.
48 Message The installer failed to modify the system jcw
JCW. (INSTERR #48).
Cause A command issued by the installer to SETVAR JCW to a
legal jcw value failed.
Action • If this error is produced, please document all messages
prior to the error. Save the file
AUTOLOG.INSTALL.SYS, and then report the
problem to the Response Center for assistance.
49 Message Error trying to RUN OCT.PUB.SYS. (INSTERR #49)
Cause Could not create OCT process. Createprocess error: status
Action • The CREATEPROCESS intrinsic returned an error
status when attempting to execute oct_filename.
• Check the returned CREATEPROCESS error in the
MPE/iX Intrinsics Reference Manual.
• Print file AUTOLOG.INSTALL.SYS to check for
further errors.
• Ensure group for OCT has sufficient capabilities. (need
CAP=PH).
• Take appropriate corrective measures and run the