HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

370 AppendixH
Error Messages and Warnings
Installer Error Messages (INSTERR)
22 Message Invalid job encountered. Job processing:
ifilename
(INSTERR #22)
Cause An invalid JOB CARD has been detected.
An invalid STREAM,# command has been detected.
Action If the USL, UXL, UNL groups were not purged prior to
starting the installation, purge them and restart the
installation procedures. Type:
:LISTF I???????.USL.SYS.
• If the file INDIRECT exists, purge it.
• Take appropriate corrective measures, and run the
installer again.
• Contact the Response Center if further assistance is
required.
23 Message An installation job stream has failed. Job
streaming:
ifilename (INSTERR #23)
Cause An installation job aborted abnormally or the installer
could not find the job's spoolfile.
Action • Ensure the spooler has been started on the LP device.
Start the spooler by entering:
:SPOOLER LP;START
• Use an appropriate text editor and view the job's
spoolfile to determine why the job failed (the PRINT
command may also be used). If you need the job
number, use an editor to view HPINSTFL. The job
numbers are listed at the end of HPINSTFL. Any
command which leaves the JCW JCW set to FATAL
will cause the installer to determine the job failed.
• Take appropriate corrective measures, and run the
installer again.
• Contact the Response Center if further assistance is
required.
24 Message 24 Not used
25 Message Unable to build a temporary file. (INSTERR #25)
Cause The installer failed to build a temporary file using the
BUILD command.
Action • Check for free temporary disk space to build file. There
are two methods for obtaining additional disk space:
— Use the ALTERVOL command in VOLUTIL to set the