HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

368 AppendixH
Error Messages and Warnings
Installer Error Messages (INSTERR)
Action • Attempt the file command manually outside of the
installer.
• Take appropriate corrective measures, and run the
installer again.
• Contact the Response Center if further assistance is
required.
18 Message The installer failed to copy SL.PUB.SYS.
(INSTERR #18)
Cause The installer failed to execute the command COPY
SL.PUB.SYS, SL to obtain a local copy of the SL.
Action • Ensure the file equation FILE SL.PUB.SYS;LOCK exists
with the LISTEQ command.
• Ensure SL.PUB.SYS exists with the LISTF command.
• Check for free disk space to copy file. There are two
methods for obtaining additional disk space:
— Use the ALTERVOL command in VOLUTIL to set the
permanent and transient space allocation
assignments to 100% on all system volumes except
LDEV 1.
— Store user files to tape and them purge them.
Restore the files from tape at the end of the
installation.
• Check if target file SL.INSTALL.SYS already exists.
Purge the SL.INSTALL.SYS file.
• Take appropriate corrective measures, and run the
installer again.
• Contact the Response Center if further assistance is
required.
19 Message The installer failed to copy XL.PUB.SYS.
(INSTERR #19)
Cause The installer failed to execute the command COPY
XL.PUB.SYS, XL to obtain a local copy of the XL.
Action • Ensure XL.PUB.SYS exists with the LISTF command.
• Check for free disk space to copy file. There are two
methods for obtaining additional disk space:
— Use the ALTERVOL command in VOLUTIL to set the
permanent and transient space allocation
assignments to 100% on all system volumes except
LDEV 1.
— Store user files to tape and them purge them.