HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

Appendix H 353
Error Messages and Warnings
SETUP Error Messages (SETERR)
attempting to VSCLOSE an open compact disk.
Action • The associated CI error message is displayed. The disk
can only be closed if no files on the disk are being
accessed. If the disk cannot be closed, determine the
files being used, kill any processes accessing the disk,
then execute SETINIT again.
• Contact the Response Center if further assistance is
required.
18 Message This disk is in an invalid state for this
process.
SETINIT will terminate. (SETERR #18)
Cause This message occurs in two instances. Either SETINIT is
attempting to VSCLOSE a disk that is in an invalid state
for the process, or SETINIT is attempting to VSOPEN a
disk that is in an invalid state.
Action • Manually VSCLOSE/VSOPEN the volume set from the
system console.
• Contact the Response Center if further assistance is
required.
19 Message SETINIT will terminate. To continue, you must go
to
the system console and VSOPEN mpe_volsetname. If
necessary, run AVRSCSI.INSTALL
to put the volume set containing SETUP.INSTUTIL
online. (SETERR #19)
Cause SETINIT is attempting to VSOPEN a volume set that is in
the “LONER” state, but is unsuccessful.
Action • Go to the system console and VSOPEN the volume set
name.
• Execute SETUP.INSTUTIL.
• Contact the Response Center if further assistance is
required.
20 Message CD v.uu.ff.SYS has garbage in its last record.
SETUP
will terminate. Follow the instructions in your
installation manual
to continue. (SETERR #20)
Cause The GRPNAMES data file is corrupted.
Action • Ensure the no file equation exists for GRPNAMES.
• Execute SETINIT.INSTALL.
• Contact the Response Center if further assistance is
required.