HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

250 AppendixD
Backdating Your System
Finishing Up
Enter Y to confirm restarting the system.
3. Boot the system from the primary boot path.
a. Boot messages can vary, depending on the system model.
b. Enter Y to the Interact with IPL? prompt, if it appears on your screen.
The system boots from disk. After some activity the ISL prompt displays.
4. At the ISL prompt, enter:
ISL>START NORECOVERY
5. Confirm the date and time.
6. Log on.
:HELLO MANAGER.SYS;HIPRI
Restart System Functions
Refer to “Restarting Selected System Functions” in Chapter 6 , “Finishing the Process,” for
additional information about any of these steps.
1. On local systems power cycle the DTCs. On remote systems reset DTCs.
If you are using OpenView DTC Manager, the DTCs do not need to be power cycled.
To power cycle all DTCs:
a. Turn DTC off.
b. Turn DTC on.
Power cycling each DTC enables the new download file and the DTC configurations to
be downloaded to the DTC(s). To reset DTCs:
a. Type:
:cstm
cstm> ru termdsm
b. At the termdsm prompt, Type R:
Connect DIag DTc DUmp EEprom Help Reset Status Trace EXit ?R
c. For each DTC, Type:
(reset)
Ldev#
POrt#,#,#
SNp #,# (X.25 card in DTC)
VC #,#,#,
Slc #,# (multiplexer card in DTC)
DTc #
(carriage return to exit) ?DTCnn