HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

Appendix D 249
Backdating Your System
Finishing Up
Where command_name is a temporary name you assigned the file. Refer to your task
checklist for the temporary name of this file.
3. Set special UDCs, if your users plan to use POSIX features on MPE/iX.
:SETCATALOG HPPXUDC.PUB.SYS;SYSTEM;APPEND
4. Log on to activate the UDCs.
:HELLO MANAGER.SYS,INSTALL
Configure Manually Installed Products
Refer to Appendix A , “Manually Installed Products,” and the appropriate product manual
for instructions. The products will not be operational until your perform the necessary
configuration changes. Manually installed products include:
• HP ALLBASE/4GL
• ALLBASE/SQL or IMAGE/SQL
• OpenView Console/System Manager
• SNA IMF/iX
• HP Predictive Support
• Non-HP (Third Party) Software
• Java/iX
Final Reboot
Refer to “Performing the Final Reboot” in Chapter 6 , “Finishing the Process,” for
additional information about these steps.
1. Shutdown the system.
CTRL-A
=SHUTDOWN
2. Reset the system.
As appropriate to your system, do either Step a or Step b:
a. For HP 3000 Series 991 or 995:
CTRL-B
CM>SP
SP>RS
Enter Y to HARD BOOT the computer system.
b. For all other systems:
CTRL-B
CM>RS
If the system does not respond, press the reset button, key switch, or on/off switch as
appropriate for your system.