HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

234 AppendixD
Backdating Your System
Performing the Backdate
a. Type at the prompt.
:sysgen
sysgen>io
io>lpath
b. Record configuration and compare to the configuration listed by ODE. Refer to
“Listing System Configuration” earlier in this appendix.
c. Change the configuration to match the ODE listing.
d. Save changes.
io>HOLD
io>EXIT
sysgen>KEEP CONFIG
purge old configuration? YES
sysgen>EXIT
A warning message displays regarding nmconfig. Ignore it.
3. Shutdown the system.
CTRL-A
=SHUTDOWN
4. Reset the system.
As appropriate to your system, do either Step a or Step b:
a. For HP 3000 Series 990-1-2 or 995-6-7:
CTRL-B
CM>SP
SP>RS
Enter Y to HARD BOOT the computer system.
b. For all other systems:
CTRL-B
CM>RS
If the system does not respond, press the reset button, key switch, or on/off switch as
appropriate for your system.
Enter Y to confirm restarting the system.
5. Boot the system from the primary boot path.
1. Boot messages can vary, depending on the system model.
2. Enter Y to the Interact
with IPL? prompt, if it appears on your screen.
The system boots from disk. After some activity the ISL prompt displays.
6. Start the system.
ISL>START NORECOVERY