HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

186 AppendixA
Manually Installed Products
Installing HP ALLBASE/4GL
Installing HP ALLBASE/4GL
To complete the installation of HP ALLBASE/4GL some additional steps must be
performed.
You must complete these installation procedures on a terminal other than the system
console. You cannot run HP ALLBASE/4GL on the system console.
First Time Install
To complete the installation of the HP ALLBASE/4GL Developer system or the HP
ALLBASE/4GL Run-Time system, perform the following steps after updating the system
with the CSLT.
1. Create the account in which you want to use HP ALLBASE/4GL. You can select any
name for the account, but HP recommends that you use the names HP4GL for the HP
ALLBASE/4GL Developer System and HP4GLR for the HP ALLBASE/4GL Run-Time
System.
Developer:
:HELLO MANAGER.SYS;HIPRI
:NEWACCT HP4GL,MGR;PASS= password &
;CAP=AM,AL,GL,ND,SF,BA,IA,PH
or
Run-Time:
:HELLO MANAGER.SYS;HIPRI
:NEWACCT HP4GLR,MGR;PASS= password &
;CAP=AM,AL,GL,ND,SF,BA,IA,PH
2. Log on to the new account and execute the following command file:
Developer:
:HELLO MGR.HP4GL
:HP4BLD.HP4GL.SYS
or
Run-Time:
:HELLO MGR.HP4GLR
:HP4BLDR.HP4GLR.SYS
HP4BLD (or HP4BLDR)will create several groups within the account. After the groups are
created, the utility copies several files from the SYS account into the newly created
groups.
3. Proceed to the section called “Install the Environment” and follow the steps to complete
the installation.