HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)
Chapter 6 151
Finishing the Process
6.1 Configuring Datacomm and UPS
When DTS/LINK is validated, NMMGR automatically invokes SYSGEN to cross-validate
the system and datacomm configurations. You have the option to customize the
cross-validation steps by modifying the commands in the file NMGRXVAL.PUB.SYS.
Comment information is contained in braces, {}. Refer to Performing System
Management Tasks and Manager's Guide to MPE/iX Security.
If inconsistencies are found during the validation or cross-validation process (such as
two separate devices configured to the same LDEV), you need to do either of the
following depending on the type of error:
• Resolve them by modifying the NMCONFIG file with NMMGR (if related to networking).
• Exit NMMGR, resolve inconsistencies using SYSGEN, then run NMMGR again to revalidate
DTS/LINK.
When cross-validation is complete, you may see this message:
Do you want DTS changes to become active now (Y/N)? N
Answer N at the prompt, and press [Return]. Press [Return] again to view the Validate
screen.
11.Exit NMMGR.
12.Shutdown the Datacommunication and Terminal Subsystem (DTS).
:DTCCNTRL FUNC=SHUTDOWN;FORCED=Y
13.Restart the DTS.
:DTCCNTRL FUNC=RESTART
14.For the network to work correctly, stream JCONFJOB.
:STREAM JCONFJOB.NET.SYS
The JCONFJOB.NET.SYS stream is required for all systems. It includes information files
that describe the supported set of servers and services. These information files are used
to build a configuration file called DADCONF.NET.SYS. Wait until the jobstream is
complete before continuing with the next step.
• Configuring Datacomm and UPS completed. Go to the next section on your
checklist.