HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

Chapter 5 137
Modifying Your System
5.14 Restarting the System
5.14 Restarting the System
If you just completed an update or install task, the system has reset itself. Otherwise,
reboot the system.
To restart the system:
1. Boot the system from the primary boot path.
a. Boot messages can vary, depending on the system model.
• If you have AUTOBOOT enabled, the system boots from the primary boot path
automatically unless you override AUTOBOOT.
• If your system prompts to enter the boot path, enter the primary boot path.
• For Model 9x8LX, 9x8RX, or 9x9KS systems, type BO at the PDC screen to boot
from the primary boot path.
• If your system prompts, Continue
with primary boot path?, enter Y.
b. Enter Y to the Interact with IPL? prompt, if it appears on your screen. After some
activity the ISL prompt displays.
c. If you want AUTOBOOT enabled and if it was turned off, turn it on now:
ISL>AUTOBOOT ON
2. Start the system. If you are using Checklist B, omit the NOSYSSTART option.
ISL>START NORECOVERY NOSYSSTART
3. Confirm the date and time.
If the date and time displayed are not correct, enter N, and enter the correct date and
time. If you do not respond within 15 seconds, the system continues.
The system displays startup and initialization messages for 5 to 6 minutes.
During the startup process, the system makes several configuration checks and may
display warning messages or error messages (for example, error messages referencing
the SPUINFOP file or DCC error messages). This is normal for system startup, and will
not affect system operation.
4. Log on and issue the following commands.
:HELLO MANAGER.SYS,INSTALL;HIPRI
:LIMIT 1,1
5. For each automatically spooled network printer.
:SPOOLER print_device ;STOP;OPENQ
where print_device is the LDEV or class of the network printer.
6. Continue log on commands
:OPENQ LP
:STREAMS streams_device