HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

134 Chapter5
Modifying Your System
5.13 Applying the CSLT Modification
5.13 Applying the CSLT Modification
This section is for applying the Customized System Load Tape (CSLT) created by
AUTOINST, HPINSTAL, or HP Patch/iX. For Manage Patch tasks, this is the CSLT/STORE
tape (not a STORE only tape). For re-installations, it is the CSLT created most recently in
SYSGEN.
To apply the CSLT tape:
1. From the console, mount reel one of the CSLT tape on the tape drive, and put the tape
drive online.
Wait until a message displays on the system console verifying that the tape is mounted.
2. If you are using the AutoRestart product and AUTOBOOT is enabled, turn it off so the
system won't automatically reboot from the primary boot path.
:RUN BLDDUMP.HP36375.TELESUP
blddump>AUTOBOOT OFF
blddump>EXIT
3. Shutdown the system.
CTRL-A
=SHUTDOWN
4. Reset the system after the last shutdown message (SHUT6).
a. If you have an HP 3000 Series 99x, connect to the service processor before you can
restart the system. Type the following:
CTRL-B
CM>SP
SP>RS
Enter Y to HARD BOOT the computer system.
Do not respond to the question:
Press any key within 10 seconds to cancel boot with this
configuration.
There are 5 to 10 minutes of system activity, then the Processor Dependent Code
(PDC) screen displays.
b. For all other systems, enter the following commands to reset the system:
CTRL-B
CM>RS
c. If the system does not respond to the CTRL-B entry within ten seconds, press the
reset button, key switch, or on/off switch as appropriate for your system. The system
will halt, and then restart automatically.
d. Enter Y to confirm restarting the system.
5. Boot the system from the alternate boot path where the CSLT is mounted.
a. Boot messages can vary, depending on the system model.