HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)
124 Chapter5
Modifying Your System
5.7 Creating the CSLT Using AUTOINST
Typing Y accepts the qualified patches. AUTOINST includes them in the CSLT, and
continues with creating the CSLT.
Typing N rejects the qualified patches, AUTOINST does not include the patches in the
CSLT, but does continue with creating the CSLT.
Do you wish to continue with installation of the patches
listed above (y/n)?
The final patch processing takes about 20–45 minutes. AUTOINST restores the patch
files and displays:
The files from the POWERPATCH tape were successfully restored.
AUTOINST processes the patch files and displays:
Processing patch files . . .Creating CSLT
c. Dismount the PowerPatch tape.
16.Mount write-enabled tape to create the CSLT. Reply to the tape request if needed.
a. AUTOINST updates temporary copies of the system libraries then creates the CSLT.
This can take up to 2 hours.
The installer will next update staged copies of the
System SL, XL, and NL. . .
b. Monitor progress messages.
The update tool checks for disk space. If you receive an error message refer to
Appendix H , “Error Messages and Warnings,” and Appendix C , “Managing Disk
Space,” for actions.
c. AUTOINST finishes creating the CSLT and displays:
Creating the CSLT ... done
Phase I of AUTOINST is now complete. Dismount and label the CSLT
AUTOINST CSLT HPVERSION
v.uu.ff
. Ensure that the write is now
DISABLED.
17.A warning message displays and lists manually installed products it cannot install, if
applicable.
Record the product names that it cannot install on your checklist.
18.A warning message displays and lists data communications products that may require
I/O configuration, if applicable.
WARNING -- The following data communication products may
require I/O configuration changes. However, this will not
affect the software installation for these products.
(INSTWARN #3)
Record on the checklist the communication product names.
AUTOINST displays the following message that indicates that the CSLT is created:
To complete the installation, perform an Update from CSLT.
19.When the CSLT is created, dismount the CSLT, write-disable it, and label it with the