HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)

118 Chapter5
Modifying Your System
5.5 Configuring the System
• Starting the System completed. Go to the next section on your checklist.
5.5 Configuring the System
You need to configure the following devices for AUTOINST to work properly:
• LP device class
• streams device (usually 10)
• tape drive (that matches the FOS and SUBSYS media type)
If you need information about hardware device IDs, print the file IODFAULT.PUB.SYS on
your screen. This file contains ID numbers and associated parameters for hardware
devices. You can display this file when the system is up and you have the system prompt.
To configure your I/O and save the customized set of configuration files, perform the
following steps:
1. Log on at the console.
:HELLO MANAGER.SYS
2. Modify or restore configuration files.
:sysgen
sysgen>IO
IO>LPATH
3. Record configuration, compare, and change the configuration to match the configuration
listed by ODE. Refer to “Listing the System Configuration,” in this chapter. For
information on SYSGEN refer to the System Startup, Configuration, and Shutdown
Reference Manual.
4. Save changes.
IO>HOLD
IO>EXIT
sysgen>KEEP CONFIG
purge old configuration? YES
sysgen>EXIT
A warning message displays regarding nmconfig. Ignore it.
5. Shut down the system.
CTRL-A
=SHUTDOWN
6. Reset the system after the last shutdown message (SHUT6).
a. If you have an HP 3000 Series 99x, connect to the service processor before you can
restart the system. Type the following:
CTRL-B
CM>SP