HP e3000 MPE/iX Release 6.5 System Software Maintenance Manual (30216-90325)
114 Chapter5
Modifying Your System
5.2 Applying the SLT
TASK. IT DESTROYS ALL THE EXISTING SYSTEM AND USER FILES IN
THE MPEXL_SYSTEM_VOLUME_SET!
b. Type at the prompt:
ISL>INSTALL
c. Go to Step 10.
10.Confirm the date and time.
If the date and time displayed are not correct, enter N, and enter the correct date and
time. If you do not respond within 15 seconds, the system continues.
The install process displays an initialization message similar to:
MPE/iX launch facility
Install
x.nn.nn
Copyright (c) Hewlett-Packard 1987
Install -- MPE/iX Disk Image Builder -- version 1.0
Initialize_genesis - Version: <<870204.1552>>
TUE, APR 19, 1994, 10:20:03 AM (y/n)? Y/N
[TMUX_DAM]
n n n n
Initialize memory manager completed.
Begin ...
The update and install processes display start-up and initialization messages. Until all
the files are restored, monitor the process from the console and note any errors that are
reported. The update or install process takes about 20–40 minutes.
If you receive an error message refer to Chapter H , “Error Messages and Warnings,”
and Appendix C , “Managing Disk Space.”
11.Boot the system from the primary boot path.
a. Boot messages vary depending on the system model.
• If you have AUTOBOOT enabled, follow the instructions on the screen and strike
any key within 10 seconds.
• If your system prompts to enter the boot path, enter the primary boot path.
• For Model 9x8LX, 9x8RX, or 9x9KS systems, type BO at the PDC screen to boot
from the primary boot path.
• If your system prompts, Boot from primary
boot path?, enter Y.
b. Enter Y to the Interact with IPL? prompt, if it appears on your screen.
The system boots from disk. After some activity the ISL prompt displays.
• Applying the SLT completed. Go to the next section on your checklist.